Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Fever alarm
The thermometer has a built-in optical indicator to warn you in case of elevated
body temperature. The coloured display shows you the temperature range that
is to be estimated.
Temperature
Display
<32.0 °C / 89.6 °F
LO
32.1 °C – 37.4 °C /
green
89.6 °F – 99.5 °F
37.5 °C – 37.9 °C /
orange
99.5 °F – 100.2 °F
38.0 °C – 43.0 °C /
red
100.4 °F – 109.4 °F
>43.0°C / 109.4 °F
Hi
If the device's LED lights up red during temperature measurement, body
temperature should be kept under constant observation and medical
advice sought in case of any uncertainty.
The use of the device does not in any way replace examination by a doctor. In
case of high fever or unclear measurement results, always seek advice from a
doctor.
Measured body
Signal tone
temperature
(Beep)
too low
1x long
normal
1x long
elevated
1x long
high
6 x short
too high
6 x short
- 26 -
Measurement mode: Object/ambient temperature
If possible, the measurement of liquids should take place from outside the vessel
to avoid any condensation forming on the sensor. The warning indicator is
switched off in this mode. The display is constantly lit in green.
The object/ambient temperature mode shows only the exposure temperature
of the surface/room temperature, and does not provide any indication of body
temperature. This measurement mode cannot therefore be used to measure fever.
Set the regulator to object measurement
temperature measurement. Point the thermometer at the desired object and
press the measure button. Read the measured temperature on the display.
Setting functions
You can adjust the thermometer according to your own particular needs. To do
so, follow these instructions.
Memory function:
1. Make sure that the thermometer is switched off.
2. Press and hold the On/Off button for approx.
2 seconds, until the display shows "MEM".
. Follow steps 1 to 3 as for body
- 27 -
Advertenties
Inhoudsopgave
