Inhoudsopgave
Advertenties
2.
Connect the end of the cable coming from the controller which will have a (female) 3 pin connector to the input
connector of the next fixture consisting of a (male) 3 pin connector.
3.
Then, proceed to connect from the output as stated above to the input of the following fixture and so on.
MASTER/SLAVE FIXTURE LINKING
1.
Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first fixture.
2.
Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to the input
connector of the next fixture consisting of a (male) 3 pin connector. Then, proceed to connect from the output as stated
above to the input of the following fixture and so on
Often, the set up for Master-Slave and Stand-alone operation requires that the first fixture in the chain be initialized for this
purpose via either settings in the control panel or DIP-switches. Secondarily, the fixtures that follow may also require a slave
setting. Please consult the '' Operating Instructions» section in this manual for complete instructions for this type of setu p
and configuration.
NAVIGATION THROUGH THE CONTROL PANEL
Access control panel functions using the four panel buttons located directly underneath the LCD Display..
Button
Function
MENU
Used to access the menu or to return to a previous menu option
UP
Scrolls through menu options in ascending order
DOWN
Scrolls through menu options in descending order
ENTER
Used to select and store the current menu or option within a menu
When a menu function is selected, the display will show immediately the first available option for the selected menu
function. To select a menu item, press <ENTER>.
MENU MAP
Press the <MODE> button repeatedly until you reach the desired menu function. Use the <UP> and <DOWN> buttons to
navigate the menu options. Press the <ENTER> button to select the menu function currently displayed or to enable a menu
option. To return to the previous option or menu without changing the value, press the <MODE> button. After a few seconds,
the LED Display will back during operation until another button is pressed.
Addr
d001-d512
19CH
CHnd
14CH
Auto
SLnd
Soun
SH 0
SH 1
SHnd
SH 2
SH 3
SEnS
0-99
OFF
4
Manual - STAR-WASH
OPERATING INSTRUCTIONS
512 address setting
19 channel settings
14 channel settings
Automatic mode
Sound-controlled operation
Effect 0 (recommended)
Effect 1
Effect 2
Effect 3
Sound sensitivity adjustment
Screen off after 5 seconds of inactivity
8.8.8.8.
MENU UP
DOWN ENTER
Advertenties
Inhoudsopgave
