Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
MAKING A CUT
CAUTION
8
a) Rest the tile on the worktable, with the cutting
point aligned. Position the carriage and set up
the cutting wheel using the side levers.
b) Proceed to cut the glaze by pushing on the
movement rod and exerting a constant
downward pressure for the entire length of the
tile.
9
c) Position the breaking foot using the side levers
on the carriage.
d) Then exert a gradually increasing pressure
until the tile is separated.
Use the graduated rods and the adjustable square for
repetitive cuts and / or specific cutting angles.
CAUTION
WHEN WORKING WITH HARD TILES, IT IS
ADVISABLE TO PRESS THE BREAKING FOOT
AGAINST ONE END OF THE TILE UNTIL IT STARTS
TO SEPARATE. COMPLETE THE BREAK BY
PRESSING ON THE OTHER END.
ROUTINE MAINTENANCE
CAUTION
a) Remove any encrustation or residue from the
carriage rod, without lubricating it.
9
b) Adjust the cutting wheel by tightening the 3
mm male hexagonal-headed screw using the
wrench supplied, to remove any lateral play,
without blocking it.
10
c) Remove all vertical play on the carriage by
tightening the screw indicated, using the 2,5
mm Allen wrench provided.
11
d) Remove all lateral play on the carriage by
tightening the screws indicated, using the 2
mm Allen wrench provided.
Excessive adjustment of the screws will prevent the
cutting carriage sliding properly.
12
e) When required, lubricate the vertical sliding
seating on the H-shaped support for the foot.
DISPOSAL
When the entire machine or part there of is disposed
of, the materials are to be disposed of in accordance
with current legislation.
Steel
Steel
Aluminium
Steel
14
Battipav srl
Worktable
Carriage
Carriage rod
AC
AC
AL
AC
Advertenties
Inhoudsopgave
