Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Only use orginal spare parts or accessories. If not
orginal parts or accessories is used, the liablility is
no longer applied.
Miscellaneous
The motor is not pre-filled with oil.
Always before start check the engine oil level.
Factory-fitted control devices, such as the handle-
mounted clutch cable, must not be removed or
exposed.
Only drain the fuel tank outdoors. Gasoline is
extremely flammable and the fumes are explosive.
Ensure that the machine is properly secured when
transported on a flatbed etc.
The lawnmower is manufactured according to the latest
safety requirements. These include a blade brake that
stops the motor and blade in 3 seconds when the blade
brake. Every precaution is only effective when it is
followed exactly. Use the following description when
you mount your lawnmower.
Identification of the parts
See Illustration 1
A.
Handlebar for engine brake
B.
Wing nut
C. Grass collector
D. Rear discharge guard
E.
Recoil starter
F.
Gasoline filling cap
G. Oil filling cap
H. Air Filter
I.
Primer
J.
Spark plug
K.
Exhaust
Mounting
Unpacking:
Remove the mower from the box by pulling the machine
out form the side.
Warning: Ensure that cable is not pinched.
Handlebar: Illustration 2
1.
Insert the 2 lower handlebars into the cutting deck.
Fasten with screws.
2.
Attach the upper handlebar on the lower. Fasten
with wing nuts from the inside of the handlebar.
3.
Customize cable and secure with cable clamp.
Mounting the engine brake cable: Illustration 3A
1.
Gently push the top handlebar forward
2.
Insert the engine brake cable from the outside, into
the hole in the bracket on handlebar and lock.
Mounting the recoil-starter: Illustration 3B
1.
Pull the engine brake handlebar and hold, in order
to release the starter cord on the engine.
2.
Pull gently the starter cord from the engine
(Engine brake handlebar MUST be hold)
3.
Attach the starter grip on the rack of handlebar.
4.
Release the engine brake handlebar and the
starter grip.
Mounting the wheesl. Illustration 4
Mount the wheels as shown.
Mounting the grass collector: Illustration M6
Click the frame to the grass collector.
Attach the grass collector under the rear discharge
guard.
Cable Adjustment
Before the machine is being used, the cable adjustment
should always be checked.
The cables can be checked by activating the handles
fully and check if the cable is tight. If not, it must be
tightened. If the handle cannot easily be fully activated,
the cable should be loosened.
After first season, it must be expected that the cables
need to be adjusted for optimal activation, as cables
can stretch when used.
The following cables may be necessary to readjust:
Cable for engine brake
Adjusting the engine brake cable: Illustration 6
If you experience slack in engine brake cable, this can
be solved simply by tighten or loosen the bolt on the
engine block.
Operation
Always check and refill oil before the start!
Add about 0.45 l. engine oil.
Illustration 7
The oil level should always be between min. and max
on the dipstick. Fill with SAE-30 oil. There should be
total 0.45 litre oil in the engine. Use only unleaded E5
fuel to the engine. Never overfill the tank.
Cutting height adjustment: Illustration 8
The mower has 3 different heights. The cutting height
ranges from 35 mm to 70 mm. Fit the wheel bolt into
one of the 3 holes. Choose the same hole position for
all 4 wheels.
Start: Never start the mower directly on long grass.
Recoil with primer: Illustration 9
1.
Push the primer several times, first time push 1-3
times, if necessary, supplement with up to 3-5
times.
Note: It is not possible to drown engine
2.
Hold the handlebar for the engine brake; this will
release the engine brake.
3.
Pull the recoil starter gently until you feel resistance
in the rope, then pull quickly and energetic. Do not
at any time let go of the recoil starter but slide it
gently into starting position.
Note: As long as operating the mower, the bar
forengine brake must be engaged.
Stop:
Release the engine brake and self-propelled bar to turn
off the mower and the engine
Note: The blades will still rotate at up to 3
seconds after stopping.
11
Advertenties
Hoofdstukken
Inhoudsopgave
