Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Instructions for installation and use
Connecting the cables
● Connect your sauna control unit to the web server (connection 1 or 2).
► Use the network cables included with the delivery for connection.
● Connect the web server to your LAN network/WLAN router (Ethernet 4).
► Use the network cable included with the delivery for connection.
● Connect the power supply unit included with the delivery to a voltage supply
(5 V DC mains input 3).
● Pro D only:
► The Pro D BUS converter RS485 is required to establish a connection
between the sauna controller and the web server. This converts the
internal CAN-BUS to RS485.
► Use the Y-distributor included with the converter to connect the converter
to the control unit as well.
Checking the connection:
After successfully connecting the web server and the sauna control unit,
the transmission indicator lamp 6 and the reception indicator lamp 7 start
to flash.
This means: The web server is sending and receiving data.
If this is not the case, check the following items:
– The sauna control unit is switched on.
– The web server has a voltage supply and is operating.
– The cable connection between the sauna control unit and the web
server is in order.
The web server requires up to 2 minutes until it has started up and is
ready for operation after being plugged into the power supply.
p. 10/26
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
