Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2. Setting of Temperature
Plug in the power plug and place a cup or similar on the cover of drip tray. Then set the
desired temperature. Switch on the device, the lamp lights up in green.
The water is heated and flows into the cup. Switch the device off, when the desired amount of
water has been dispensed.
► If device was not used for longer time there could be scale deposits despite water filter. In
this case let 100 ml with 100 °C run through the device.
► The ambient temperature changes everyday. This leads to different amounts of water. It
can vary up to +- 15%.
3. Water disposal from the drip tray
1. When the drip tray is full, grasp and stabilize the
appliance by one hand and use the other hand to
lift up the drip tray slightly to remove it.
2. Remove the cover of drip tray.
3. Empty the drip tray, replace cover of drip tray, and
insert it into the original place. Make sure it is
properly inserted.
4. Replacing the filter
1. Open the tank cover and take out the box with the filter.
2. Soak the filter upright in water for 10 min.
3. Rinse the filter under running water for 10 sec.
4. Remove the old filter and replace it with a new filter (see fig.). Therefor take out the filter
box, place the new filter and pull it down from the bottom.
Please note
29
Advertenties
Inhoudsopgave
