Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
28. When using and you hear a squeaking sound from the vacuum cleaner, or suction power appears to be
reduced, stop the machine immediately and clean all filters and change the dust bag.
29. WARNING: Hold the plug when rewinding the cord. Do not allow the cord to whip when rewinding.
The general purpose vacuum cleaner (model VE-109959.26), has been tested according to EN 60312-1 and
complies with the essential requirements of regulation (EU) 666/2013 for vacuum cleaners.
PARTS AND ACCESSORIES
1.
On/off switch pedal
2.
Cord rewinder pedal
3.
Dust full indicator
4.
Combi nozzle
5.
Hose
6.
Tube
7.
Floor brush
8.
Handle
OPERATING MODE
1.
Connect the hose accessories:
Press the adaptors at both side of the hose end, and insert the hose into the hose socket.
2.
Connect the two pieces plastic tubes together. Then, connect one end of the tube to the curved hose end
and the other end to the different nozzle tools/floor brush for different cleaning purposes.
The floor brush has two positions, one for hard and one for soft/textile surfaces – Choose the right one.
3.
Turn on the appliance:
Hold the plug and pull out the cord, then insert the plug into the power socket. Make sure that the power
supply corresponds to the required power mentioned on the rating label. Press the on/off switch pedal to
turn on the power.
4.
Turn off the appliance:
After using, press the on/off switch pedal, the appliance is turned off. Pull the plug out of the power
socket; press the cord pedal, the power cord will be drawn in.
5.
To move the appliance from room to room, unplug and carry it by using the handle. Never pull the
appliance by its cord when moving.
MAINTENANCE
When the dust full indicator turns to red, it is time to clean the dust bag or replace with a new bag. To do that,
please follow the instructions:
a)
Open the front cover by pressing the lock clip.
b)
Remove the dust bag.
c)
Then take a new one, insert it into the bag holder.
d)
Close the front cover.
NOTE:
1.
The front cover cannot be closed unless the dust bag is installed in right position.
2.
The motor protection filter (A) should be removed and rinsed twice a year or whenever it is visibly
clogged. If the filter is damaged, a new filter should be replaced.
- 8 -
Advertenties
Inhoudsopgave
