Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
off until the steamer is ready , once this
happens the indicator will remain constant,
indicating that it is fully ready to iron. This
process takes about 60" and is controlled by the
product's electronics.
• Do not use temperatures higher than those
indicated on the garments to be treated.
● Temperature for synthetic fibres (Polyester,
Nylon...). (don't use this position to produce
steam)
●● Temperature for silk, wool. (Minimum tempe-
rature for ironing with steam)
●●● Temperature for cotton.
Max Temperature for linen.
• If garment has various kinds of fibres, select the
temperature for the fibre that requires the lowest
temperature. (For example, select the tempera-
ture for polyester for an article made out of 60%
polyester and 40% cotton).
• Wait until the pilot light (B) has gone out which
will indicate that the appliance has reached an
adequate temperature.
• Press and hold the steam button (C) for 10
seconds
• During use the pilot light (B) will automatically
flash on and off, thus indicating that the heating
elements are operating in order to maintain the
desired temperature.
DRY IRONING:
• The appliance has a steam and temperature
control (E) which when set to the MIN position
allows dry ironing (no steam).
STEAM IRONING:
• It is possible to iron with steam whenever the
deposit is filled with water and the adequate
temperature is selected.
STEAM FLOW CONTROL:
• The appliance allows the temperature and
steam flow (E) to be regulated, to adjust the
steam use a higher or lower temperature and
the appliance's electronics will adjust the steam
accordingly
• If the light (O) is switched, the water tank is
without water.
ANTI-SCALE WARNING:
• ANTI-SCALE FILTER: To ensure correct ope-
ration, replace the anti-scale filter after every 6
months of continued use.
into its housing. Use demineralised water to
continue using an already depleted cartridge.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
• Select the minimum position (MIN) using the
steam and temperature control.
• Unplug the appliance to the mains.
• Remove the water from the water tank.
• Clean the appliance
CLEANING
• Disconnect the appliance from the mains and let
it cool before undertaking any cleaning task.
• Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
• Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
• Do not submerge the appliance in water or any
other liquid, or place it under a running tap.
• Quick cleaning guide:
1) Fill the tank with approximately 1 litre of water.
(Do not put vinegar or other descaling agents
into the water tank)
2) Plug in the ironing system and set the tempera-
ture control to MIN.
3) Hold the iron vertically over the sink and press
the steam button (C) for 1 minute to pump the
water from the tank to the iron.
4) Increase the iron's temperature setting to
number 2
5) Place the iron horizontally over the sink, keep
pressing the steam button (C) and gently rock
the iron backwards and forwards for 1 minute.
6) Unplug the ironing system from the mains
supply and immediately rub the soleplate with a
damp cotton cloth folded several times. (Never
Fit the new cartridge
Advertenties
Inhoudsopgave
