Advertenties
Beschikbare talen
Beschikbare talen
13. Storing the appliance
See the leaflet sides
1. Set the power button to the "O" position and
disconnect the mains cable.
2. Always allow the appliance to cool down
before storing it.
3. Place the iron on the iron pad (2), standing on
the soleplate, and fix it by inserting the tip of
the iron into the front slot and moving the lock
system (3) against the heel of the iron.
4. Empty the water tank, store the mains cable
on the cord storage facility and the steam
hose in the storage fixing. Do not wrap the
cords too tight.
5. Hold the iron´s handle when moving the
appliance.
Trouble shooting
Problem
The "Calc" indicator
light (4) flashes.
The ironing programme
indicator light (7)
flashes continuously.
The steam generator
does not come on.
The iron does not heat
up.
The iron begins to
smoke when switched
on.
Water flows through the
holes on the soleplate.
* Model dependent
Possible causes
1. Boiler and iron must be rinsed.
1. The water tank (1) is empty.
1. There is a connection problem.
2. The power button is not
switched on.
1. The power button is not
switched on.
2. The temperature is set to a low
position.
1. During first use: certain
components on the appliance
have been lightly greased at the
factory and may produce a little
smoke when initially heated.
2. During subsequent use: the
soleplate may be soiled.
1. The water is condensing inside
the pipes because steam is being
used for the first time or has not
been used for a long time.
Tips to help you save energy
Steam production consumes the most energy. To
help minimise the energy used, follow the advice
below:
• Start by ironing the fabrics that require
the lowest ironing temperature. Check the
recommended ironing temperature on the
label on the garment.
• Try to iron the fabrics while they are still damp
and reduce the steam setting. Steam will be
generated from the fabrics rather than the
iron.
• If you tumble dry your fabrics before ironing
them, set the tumble drier on the 'iron dry'
programme.
Solution
1. Rinse the boiler and the iron according
to the cleaning instructions in this
manual.
1. Fill the water tank.
1. Check the mains cable (13), the plug
and the socket.
2. Set the power button (10) to the "I"
position.
1. Set the power button (10) to the "I"
position.
2. Set the temperature to the desired
position.
1. This is completely normal and will stop
after a short while.
2. Clean the soleplate according to the
cleaning instructions in this manual.
1. Point the iron away from the ironing
area and press the steam release
button until steam is produced.
21
BOS CH
Advertenties
