Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
TFA_No. 35.1166_Anleitung
Wireless weather station
Note on radio-controlled time
• The time is transmitted from an atomic clock near Frankfurt am
Main by a DCF-77 (77.5 kHz) frequency signal with a range of
about 1,500 km. Your radio-controlled clock receives the signal,
converts it and always shows the exact time. The adjustment of
Daylight Saving Time and Standard Time is also automatic.
• Avoid being close to possible sources of interference that may
affect radio reception (see "Location and mounting").
• During night-time, the atmospheric interference is usually less
severe. A single daily reception is adequate to keep the accuracy
deviation under 1 second.
6. Operation
• The device will automatically quit the setting mode if no button
is pressed for 20 seconds.
• Press and hold the MAX/+ or –/MIN button in setting mode for
fast mode.
6.1 Manual settings
• Press and hold the SET button for three seconds to enter the
setting mode.
• The first adjustable value flashes on the display.
• Use the MAX/+ or –/MIN button to make the desired setting,
while the value flashes.
• Confirm with the SET button and go to the next setting.
• The sequence is shown as follows:
– DCF reception ON/OFF (default: DCF ON)
– Time zone -12/+12 (default: DCF 00H)
– Hours, minutes
– Year, month, day
– Automatic reset of the maximum and minimum values
ON/OFF (default: AUTO OFF MAX MIN)
6.1.1 DCF reception
• By default, the DCF reception is activated (DCF ON) and after
successful reception of the DCF signal no manual time setting is
necessary.
• In the setting mode, you can deactivate (DCF OFF) or activate
again the DCF reception using the MAX/+ or –/MIN button.
• Once the DCF time reception is deactivated the clock must be
manually set. No time zone will appear.
04.07.2022
15:45 Uhr
– 30 –
Seite 16
Wireless weather station
• If the DCF reception is activated, the manually set time will be
overwritten by the DCF time when the signal is received
successfully.
6.1.2 Time zone setting
• In the setting mode, use the MAX/+ or –/MIN button to make the
time zone correction (-12/+12).
• The time zone correction is needed for countries where the DCF
signal can be received but the time zone is different from the
DCF time (e.g. +1=one hour plus).
6.1.3 Automatic reset of the maximum and minimum values
• In the setting mode, you can activate (AUTO MIN MAX ON) or
deactivate again the automatic reset of the maximum and mini-
mum values using the MAX/+ or –/MIN button.
• If the automatic reset is activated, AUTO appears on the display.
• The maximum and minimum values will be reset automatically
every midnight at 0:00 (see "Reset of maximum and minimum
values").
6.2 Temperature
6.2.1 Indication of maximum and minimum values
• Press the –/MIN button in normal mode. MIN flashes on the dis-
play.
• You can now see the lowest indoor temperature measuring
value since the last reset with time and date of recording.
• Press the –/MIN button and go to the outdoor temperature.
• If you have installed more than one transmitter, press the
CHANNEL button to change between the outdoor transmitters.
• Press the –/MIN button once more to go back to the current
values display.
• Repeat the process by pressing the MAX/+ button to see the
maximum values. MAX flashes on the display.
6.2.2 Reset of maximum and minimum values
a) Manual reset
• Press and hold the SET button for 3 seconds while the highest
or lowest values are displayed. The values will be deleted and
reset to the current state.
– 31 –
Advertenties
Inhoudsopgave
