Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally
friendly and natural gas, it is explosive. Therefore you should be careful during shipment and
installation to prevent your appliance's cooler elements from being damaged. In the event of
a leak caused by damage to the cooler elements, move your fridge from open flame or heat
sources and ventilate the room where the appliance is located for a few minutes.
CLEANING
Do not use abrasive cleaning agents or solvents.
1.
Disconnect the mains plug from the mains socket.
2.
Take out the food and store in a cool location.
If necessary, defrost the refrigerator/freezer. To speed up the process, a pan of hot water
3.
can be placed in the freezer.
Wipe the condensation off with a cloth or sponge.
4.
Clean the appliance with a soft cloth, warm water and detergent.
5.
Wipe the door seal with clear water only and then wipe dry thoroughly.
6.
After cleaning reconnect and adjust the temperature control knob as desired.
7.
8.
Put the food back into the appliance.
DOOR CONVERSION
1.
Remove the cover plate of the screws. Remove the three screws and then the upper
hinge that holds the door in place. Lift the door off and place it on a soft surface to
prevent scratching.
On the bottom of the door there is a door stop and a Teflon bush to guide the hinge.
2.
Move this to the other side.
ew and plastic
42
DO927BFK