Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
english
6 Troubleshooting
Display
Problem
Paper
jam
Continu-
ous lamp
Overload • The motor was overloaded. Let the shredder cool down for approx.
Flashing
General
light
fault
displays
Shredded
material
container
full
Door
open
14
Measure
You have fed in too much paper.
The cutting unit runs in reverse for a few seconds and pushes the
paper back out again.
• If necessary, press the reverse button "R" to remove the stack of paper.
• Take half the stack of paper.
• Feed the paper in portions.
15 – 20 mins. before using it again.
• A fault has occurred while shedding paper.
Pull the paper out of the slot to clear the light barrier.
• Empty the shredded material container.
Note:
If you press the reverse button briefl y before removing the container,
part of the material is pulled back into the cutting apparatus and does
not fall inside the document shredder.
• Close the front door.
SECURIO B 26
11/2022
Advertenties
Inhoudsopgave
