Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ENGLISH
Operation OR 2000-9 DT &
OR 2500-11 DT
Setting the heating power
1) Plug the power cord into an appropriate outlet.
Make sure your power supply is properly
protected.
2) Switch on the device with the mains switch [1]
(beep sounds and switch lights up red).
3) Use the power level button [2] to set the desired
heating power.
Press button 1x = high power
(OR 2000-9 DT: 2000 W / OR 2500-11 DT: 2500 W)
Press button 2x = medium power
(OR 2000-9 DT: 1200 W / OR 2500-11 DT: 1500 W)
Press button 3x = low power
(OR 2000-9 DT: 800 W / OR 2500-11 DT: 1000 W)
Press button 4x = device is on standby
Note:
The power levels are indicated by small symbols
at the top right of the display [3].
Temperature setting
1) Use the power switch [1] to switch on the
device.
2) Press the power level button [2].
The number "88" flashes on the display [3].
3) Press the mode button [4].
The display [3] shows "24 °C" (or 75 °F) and a
flashing thermometer symbol.
4) Use the °C / °F button [5] to select the desired
unit for the temperature display.
5) Use the + [6] and - [7] buttons to set the desired
temperature. The temperature value is shown
on the display [3] and can be changed at any
time.
26
Programming the switch-off time (AUTO OFF).
This function is used to set when the oil-filled radiator
switches off automatically.
1) Once the temperature is set, press the mode
button [4] again. "AUTO OFF" flashes on the
display [3].
2) Use the + [6] and - [7] buttons to set a time
between 1 and 24 hours.
3) The "AUTO OFF" indicator lights up continuously
after approx. 10 seconds. The oil-filled radiator
will then switch off at the set time.
Programming the switch-on time (AUTO ON).
This function is used to set when the oil-filled radiator
switches on automatically.
1) Once the temperature is set, press the mode
button [4] twice. "AUTO ON" flashes on the
display [3].
2) Use the + [6] and - [7] buttons to set a time
between 1 and 24 hours.
3) The "AUTO ON" indicator lights up continuously
after approx. 10 seconds. The oil-filled radiator
will then start heating at the set time.
Switching off the device
1) Keep pressing the power level button [1] until
the display [3] turns off.
2) Use the mains switch [3] (position 0) to switch
off the device.
3) Pull out the power cord from the wall outlet.
Advertenties
Inhoudsopgave
