Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
LIPROTEC
Adjusting the colour temperature (RGB+W receivers
only)
1. Press the
> The signal lamp on the Bluetooth remote control flash-
es evenly. You can set the colour temperature.
2. To increase the colour temperature (light becomes bluer),
press the + button.
3. To reduce the colour temperature (light becomes redder),
press the - button.
4. To finish setting the colour temperature, do not press any
buttons on the Bluetooth remote control for five seconds.
> The signal lamp on the Bluetooth remote control stops
flashing. The + and - buttons now adjust the bright-
ness again.
Selecting Favourites using the Bluetooth remote
control
Presets for the colour temperature, brightness and, where ap-
plicable, colour are known as Favourites ( » "Using Favourites"
on page 36 ). You can use the Bluetooth remote control to
select these Favourites.
1. To call up a Favourite that is allocated to one of the 1–4
buttons, press the
> The signal lamp on the Bluetooth remote control flash-
es evenly. Buttons 1–4 call up presets for the colour
temperature, brightness and, where applicable, colour.
These presets are also known as Favourites.
2. Press one of the buttons 1–4.
> The Favourite assigned to the button is called up.
button.
button.
EN
35
Advertenties
Inhoudsopgave
