Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
LIPROTEC
The Bluetooth remote control can be used to control up to
four groups. Each group is assigned a button, 1–4. This but-
ton is used to call up the group.
If you no longer wish to control a Bluetooth mesh receiver
through a group, you can exclude it from the group.
Adding Bluetooth mesh receivers to a group
1. Disconnect the mains power supply to the Bluetooth mesh
receiver that you want to add to a group. To do this, pull
the power supply unit out of the mains socket.
2. Reconnect this Bluetooth mesh receiver to the mains sup-
ply (plug it into the socket).
3. Within 20 s, press the
control at the same time.
4. Press one of the buttons 1–4. This button is the number
of the group to which the Bluetooth mesh receiver is now
added.
> All LED modules connected to the Bluetooth mesh
receiver flash briefly three times. The Bluetooth mesh
receiver has been added to the selected group.
Removing Bluetooth mesh receivers from a group
1. Disconnect the mains power supply to the Bluetooth mesh
receiver that you want to remove from a group. To do this,
pull the power supply unit out of the mains socket.
2. Reconnect this Bluetooth mesh receiver's power supply to
the mains (plug it into the socket).
3. Within 20 s, press the
control at the same time.
and + buttons on the remote
and + buttons on the remote
EN
31
Advertenties
Inhoudsopgave
