Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
English
BLOWING FEATURE (Fig. C)
WARNING: To avoid injury to bystanders, keep
them clear of blowing debris.
The vacuum contains a blowing feature. It has the
capability to blow sawdust and other debris. It can
be used to blow dust and debris out of garages or off
patios and driveways. Follow the steps below to use
the vacuum as a blower.
1. Locate blowing port on the vacuum.
2. Insert one end of the hose into the blowing port.
3. Turn vacuum "ON".
STORAGE (Fig. A)
1. Empty dust tank, refer to TO EMPTY DUST TANK
instructions.
2. Clean the vacuum inside and outside. refer
to CLEANING.
3. Clean or replace lters, refer to FILTER.
4. Store the hose and the power cord, as
shown in the Fig. A. Place the appliance in
a dry room and secure it from unauthorized use.
OPTIONAL ACCESSORIES
WARNING: Since accessories, other than those
offered by D
WALT, have not been tested with this
E
product, use such accessories with this appliance
could be hazardous.
To reduce the risk of injury, only D
recommended accessories should be used with
this product.
CLEANING
To keep the wet/dry vacuum looking its best, clean
the outside with a cloth dampened with warm water
and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and mild
soap.
3. Wipe with dry cloth.
TROUBLESHOOTING
:
WARNING
TO REDUCE THE RISK OF INJURY FROM
MOVING PARTS AND/OR ELECTRICAL SHOCK,
TURN POWER SWITCH OFF AND DISCONNECT
GROUNDED PLUG FROM ELECTRICAL OUTLET
BEFORE PERFORMING TROUBLESHOOTING
CHECKS.
Minor problems often can be xed without calling
customer service.
WALT
E
be replaced by the manufacturer, its service agent or
similarly quali ed persons in order to avoid a hazard.
This product is NOT to be used for ltering of
pathogens, for example COVID-19. Follow all local,
state and federal guidance on general cleaning
practices.
17
PROBLEM
Check power cord, plugs and outlet.
Motor does not run
Ensure the on/off switch is in the
ON position ( I )
Remove blockages in the oor
nozzle, extension wands, hose
or lter.
Replace the disposable dust bag.
Suction capacity
Check for proper installation of
decreases
the lter.
Clean or replace the lter.
Empty dust tank, refer to EMPTY
THE TANK under OPERATING
INSTRUCTIONS.
Thermal overload has been tripped:
1. Turn the vacuum off and
disconnect vacuum cleaner from
power source.
2. Empty the dust tank, if needed.
Vacuum stops
3. Allow the unit to cool.
running
4. Plug the power cord into an
appropriate outlet and turn on/off
switch to the ON position ( I ) to
test.
Check for proper installation of the
lters.
Ensure lters are not damaged;
Dust comes out
replace if necessary.
while vacuuming
Ensure lter seals are in place and
are secure.
Check the t of the vacuum head.
If the supply cord is damaged, it must
WARNING:
WARNING:
TOOL GUARANTEE
SOLUTION
3
YEAR
LIMITED
GUARANTEE
Advertenties
Inhoudsopgave
