Inhoudsopgave
Advertenties
RECHARGEABLE BATTERY OPERATION
Prior to operating the device off mains for the first time, the rechargeable battery must be fully charged.
Switch on the device with the power switch. The operating time of the battery depends on the operating mode and the ambient
1.
temperature. After the operation, switch the device off.
For charging the battery, connect the device to a power outlet via the enclosed adapter. The device may be operated during the charging
2.
procedure.
The device features a protective circuit for charging which prevents overload of the rechargeable battery. However, disconnect the device
3.
from the mains after charging. Otherwise there will be a low current consumption even if the device is switched off.
The device will heat up during charging; this is normal.
4.
To prevent damage to the battery by deep discharge, recharge a battery completely discharged as soon as possible. Do not store the unit
5.
with the battery completely discharged and regularly recharge the battery in case of long storage.
DMX512 CONTROL
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX chain.
Always connect the output of one unit with the input of the next unit until all units are connected.
CAUTION! At the last unit, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor
between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.
REMOTE CONTROLLER
BLACK OUT Mode
Press <BLACK OUT> off existing modes. Press <BLACK OUT> return the last modes.
AUTO Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
1. Press <AUTO> on the remote controller.
2. Press <+> or <–> to choose between the different auto programs.
SOUND Mode
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
1. Press <SOUND> on the remote controller.
2. Press <+> or <–> to choose between the different sound programs.
STROBE Mode
To adjust the strobe speed of the automatic program and the sound active program.
1. Press <STROBE> on the remote controller.
2. Press <+> or <–> to either increase or decrease the speed of the program.
3. Press <STROBE> again to turn off the strobe.
SPEED Mode
To adjust the speed of the automatic program and the sound active program.
1. Press <SPEED> on the remote controller.
2. Press <+> or <–> to either increase or decrease the speed of the program.
5
Advertenties
Inhoudsopgave
Probleemoplossen
