Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION - Use of the clip or base
1. Press the ends of the clip together (see figure
3A).
2. Set the clip on a level surface, such as a table.
Put the clip into the base (7) and you have a
stand fan (see figure 3B).
3. Let the ends go.
OPERATION - Ventilation
1. Set the fan on a level surface,
such as a table.
2. Tilt the fan to the required angle
(see Figure 3). You can set the fan:
a. Vertically at a 45° angle. Untighten the
screw at the side of the stand. Tilt the
ventilator housing and motor housing
to the required angle. Tighten the screw.
b. To the left and right (360° around it's axis).
3. Put the plug into the wall socket.
4. Switch on the fan by selecting one of the
two speeds with the speed button (4).
a. Position '1', the fan operates at low speed.
b. Position '2', the fan operates at high speed.
5. Stop the fan by setting the speed button at
position '0'.
CLEANING AND MAINTENANCE
1. Remove the plug from the wall socket.
2. Clean the motor housing of the appliance with a damp cloth. After cleaning, dry the housing thoroughly.
3. Store the appliance.
WARNING:
•
Verify that the plug is out of the socket before you clean it.
•
Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes) to
clean the appliance.
•
Do not immerse the motor unit in water, or in other liquids.
45°
360°
25
EN
3
4
Advertenties
Inhoudsopgave
