Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problem
The sound from the
The sound level is higher than the
component connected
maximum input level for the XLR
to the BAL jack is
balanced input jacks.
degraded.
Bass is not spatial
The polarity is incorrect.
when BAL (balanced
input) is selected.
The sound is
The power of this unit is turned off.
degraded when
listening with the
headphones
connected to the CD
player connected to
this unit.
The volume level is
Incorrect setting for the PHONO switch
low while playing a
on the front panel.
record.
The remote control
Wrong distance or angle.
does not work or
function properly.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
Taking care of this unit
Polish finish on the side panels
Use of Yamaha Unicon cloth (sold separately) is
recommended. For heavy dirt, use Yamaha Piano
Unicon (sold separately). For puschasing, contact your
nearest authorized Yamaha dealer or service center.
Other finish
When you wipe this unit, do not use chemical solvents
(alcohol, thinner, etc.), which might damage the finish.
Use a clean, dry cloth. For heavy dirt, dampen a soft
cloth in detergent diluted with water, wring it out, and
clean this unit with the cloth.
Cause
If the output level of the connected component is
double, set the ATTENUATOR selector located
above the input jacks to ATT. (-6 dB).
Select the correct polarity with the PHASE selector.
Turn on the power of this unit.
Switch the PHONO switch to the MM or MC position
according to the type of magnetic cartridge of the
turntable.
The remote control functions within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
Reposition this unit.
Replace all batteries.
Remedy
See
page
20
20
—
9
14
8
14
29
En
Advertenties
Hoofdstukken
Inhoudsopgave
