Inhoudsopgave
Advertenties
14.3
Cleaning
After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal
surfaces as well as the use of scrubbing agents will damage the machine
surface!
Clean the machine surface with a wet cloth soaked in a mild solution
14.4
Disposal
Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
15
TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Machine does not start
Strong vibration
Bad turning result
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
HOLZMANN MASCHINEN GmbH
Possible cause
Switch defective
Power supply is off
Fuse is defective
Circuit breaker is active
Warped workpiece
Workpiece is wrong centered
Loosen pulley
Outworn pulley
Turning lathe is on uneven surface
Loosen tail- or headstock
Too much speed
bad sharpened chisel
Wrong chisel for this work
Wrong adjustment of tool rest
www.holzmann-maschinen.at
NOTICE
Solution
Repair switch
Repair power supply
Change fuse
Push in the circuit button
Change material
Measure the center newly
Tighten the pulley
Change pulley
Level the surface
Tighten
Adjust speed
Sharpen the chisel
Select the right chisel
Adjust the high and the
NOTICE
TROUBLE SHOOTING
distance of the tool rest
D 460FXL
30
Advertenties
Inhoudsopgave
