Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
TFA_No. 35.1155_Anl_04_21
01.04.2021
HORIZON – Wireless weather station
A 9:
Comfort level indicator of indoor climate
A 11: Moon phase
A 13: Location
A 15: Daylight Saving Time symbol
A 17: Alarm symbol 1+2
A 19: Time with seconds
A 21: Absolute or relative atmospheric pressure
A 23: Circle symbol for the alternating channel
A 25: Channel number
B: Buttons (Fig. 1+2):
B 1:
SNOOZE/LIGHT button
B 3:
Relative/Absolute button
B 5:
MAX/MIN/– button
B 7:
°C/°F/+ button
B 9:
HISTORY/WEATHER button
B 11: CHANNEL button
C: Housing (Fig. 2):
C 1:
Wall mounting holes
C 3:
Stand (fold out)
D: Transmitter (Fig. 3):
D 1:
°C/°F button
D 3:
Wall mounting hole
D 5:
Battery compartment
D 7:
Radio symbol channel 1,2,3
D 9:
Transmission indication LED
D 11: Transmission signal
20
10:10 Uhr
Seite 11
A 10: Indoor humidity
A 12: Moonrise/moonset time
A 14: Sunrise/Sunset time
A 16: DCF reception icon
A 18: Date and weekday
A 20: History values of atmospheric pressure
A 22: Outdoor temperature tendency
A 24: Symbol for MAX/MIN
B 2:
+/12/24 button
B 4:
–/
button
B 6:
MODE button
B 8:
ALARM ON/OFF button
B 10: SUN MOON button
B 12: RESET button
C 2:
Battery compartment
D 2:
TX button
D 4:
1 2 3 switch for channel selection
D 6:
Stand
D 8:
Outdoor temperature display
D 10: Battery symbol for the transmitter
HORIZON – Wireless weather station
6. Getting started
6.1 Insert the batteries
• Remove the protective films from the display of the base station and the transmitter.
• Open the battery compartment of the transmitter and receiver and place both instruments on a desk with a dis-
tance of approximately 1.5 meter. Avoid being close to possible sources of interference such as electronic devices
and radio equipment.
• Insert at first two new batteries 1,5 V AAA in the battery compartment of the transmitter and immediately after-
wards three new batteries 1,5 V AAA in the battery compartment of the base station. Make sure the polarities are
correct.
• After a successful installation close the battery compartments carefully.
6.2 Weather symbol setting
• The device will alert you with a beep and all segments will be displayed for a short moment.
• After batteries were inserted or when holding HISTORY/WEATHER button in normal mode for 3 seconds, the
weather symbol will be flashing for 20 seconds. Enter the actual weather during this time by pressing the
MAX/MIN/– or °C/°F/+ button.
• Press the HISTORY/WEATHER button to confirm the setting.
6.3 Reception of outdoor temperature
• After the batteries are inserted, the outdoor values will be transmitted to the base station. The reception symbol
for the transmitter flashes.
• If the reception of the outdoor values fails, "- -" appears on the base station display. Check the batteries and try it
again. Check if there is any source of interference.
• You can also start the outdoor transmitter search manually later on (for example when the outdoor transmitter is
lost or the batteries are changed). Press and hold the CHANNEL button for three seconds. The last registered
transmitter (channel) will be canceled.
• Press the TX button on the outdoor transmitter. The transmission of the outdoor data takes place immediately and
a successful reception will be confirmed by a beep tone of the base station.
21
Advertenties
Inhoudsopgave
