Advertenties
device must accept any radio interference encountered, even if the interference is
likely to compromise operations.
CANADA DECLARATION OF CONFORMITY (PARROT BEBOP 2 )
This device complies with the Industry Canada RSS applicable to licenseexempt radio
apparatus. Operation is permitted subject to the following two conditions: (1) the
device must not produce interference, and (2) the user of the device must accept
any radio interference encountered, even if the interference is likely to compromise
operations. This category B digital device is compliant with the NMB-003 standard
of Canada.
FCC/IC
To comply with the FCC/IC RF exposure guidelines for transmission equipment, a
distance of at least 20cm must be maintained between the product antenna and
individuals. To remain compliant you are recommended not to use the product at
any distance less than this.
This device complies with part 15 of the Industry Canada RSS applicable to license-
exempt radio apparatus.
Operation is permitted subject to the following two conditions:
1. The device must not cause interference;
2. The user of the equipment must accept any interference suffered, even if the
interference is likely to affect the operation of the equipment.
This mobile device with an antenna meets the FCC limits for radiation exposure
established for an uncontrolled environment. This device meets the limits of the
specific absorption rate (SAR) of the FCC. To ensure compliance, follow these
instructions: this transmitter must not be co-used or operated at the same time as
another antenna or transmitter.
BATTERY (PARROT SKYCONTROLLER 2 AND PARROT BEBOP 2 A)
WARNING: Failure to follow all the instructions may result in serious injury, irreparable
damage to the battery and may cause a fire, smoke or explosion.
Always check the battery's condition before charging or using it. Replace the battery
if it has been dropped, or in case of odour, overheating, discolouration, deformation
or leakage. Never use anything other than the approved LiPo charger to charge the
battery. Always use a balancing charger for LiPo cells or a LiPo cell balancer. It is
recommended that you do not to use any other charger than the one provided with
the product. Never trickle charge or charge under 3 V per cell. The temperature of
the battery should never exceed 60°C (140°F) otherwise the battery may become
damaged or ignited. Never charge on a flammable surface, near flammable products
or inside a vehicle (preferably place the battery in a non-flammable and
nonconductive container). Never leave the battery unattended during the charging
process. Never disassemble or modify the housing's wiring, or puncture the cells.
Always ensure that the charger output voltage corresponds to the voltage of the
battery. Do not short circuit the batteries. Never expose the LiPo battery to moisture
or direct sunlight, or store it in a place where temperatures could exceed 60°C (car in
the sun, for example). If the battery is not used for a long time, it will gradually
discharge. Keep your battery half charged. Always keep it out of reach of children.
For more information about batteries, visit: parrot/support
29
Advertenties
