Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
OPERATION
The PDS65 is functional both in low impedance-, as well as in 100V/70V use. Use the switch (as pictured below) to set the
pendant speaker in the correct working mode. In below case, the pendant speaker is configured to work in 8 Ohm (Ω, low
impedance) setup. The terminal block connector is located near the switch.
NOTE: Cabling of a 70/100V system may only be carried out by a qualified electrician! The total load must not exceed the rated
power of the amplifier. If the 70/100V system is turned on, turn it off before connecting. Make sure the rotary switch on the
speaker is turned to "off" before connecting.
LOW IMPEDANCE
The low impedance mode of the PDS65 has a nominal impedance of 8Ω. If there is the need to connect multiple speakers in
parallel, be sure to follow the amplifier's specifications regarding the minimum allowed impedance. Most amplifiers allow for a
minimum of 4Ω impedance, which translates to two PDS65 speakers connected in parallel.
* Both left and right amplifier output channels can be used in above
case.
70/100 VOLT
Use the rotary switch to configure the desired power tap when using the PDS65 in 70/100V configuration (5W, 10W, 20W, 40W
for 100V and 2.5W, 5W, 10W, 20W for 70V).
Make sure you are using a powerful enough amplifier for your setup of PDS65 speakers. It is recommended to have about 20%
of reserve power. In below case (100V), you will need at least roughly 140W of amplifier power ((40+40+40) x 1.2 =144W).
MOUNTING
The PDS65 pendant speaker can be suspended, as well as mounted on (for example) a wall. Before installing, please make
sure that the surface to which you are mounting the speaker, has sufficient load-bearing capacity.
For illustrated instructions on how to mount both suspended and (wall)mounted, please refer to final pages of this manual.
3
Advertenties
Inhoudsopgave
