Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
b) Manual Pairing
• Ensure that all the cables are well connected and the main unit is in Standby mode.
• Press and hold the PAIR button (24) on the rear of the subwoofer for 3 – 4 seconds. The subwoofer will
enter the pairing mode and the Pair Indicator will blink quickly.
• Switch the main unit on with the on/off switch
• After the wireless connection succeeded, the Pair Indicator will light up.
• If the Pair indicator blinks, the wireless connection has failed. Unplug the cable of the subwoofer and
then reconnect the main cable after 3 minutes. Repeat above steps for manual pairing.
If there are problems during pairing, kindly observe the following:
• If the wireless connection fails again, check if there is conflict or strong interference caused by
electronic devices. Remove these conflicts or strong interferences and repeat the above procedures.
• The subwoofer should be within 6 m of the soundbar in an open area.
• If the main unit is not connected with the subwoofer and it is in On mode, the Standby indicator (7) will
flash. Follow the above steps to pair the subwoofer to the main unit.
11. Handling
a) Switching the device on and standby mode
• After connecting the device to the mains, the Soundbar will activate the standby mode. The standby
indicator lights up red.
• Use the buttons on the device or remote control to operate the Soundbar. Some functions can only be
controlled with the remote control.
• Press the on/off switch
device back to standby mode.
• If the device does not detect any input signal for approx. 15 minutes, it will automatically switch to
standby mode. The standby indicator lights up red.
• Disconnect the power cable from the mains in order to fully turn off the device.
b) Selecting audio sources
Press the SOURCE (2) button repeatedly or press one of the audio source buttons (16) to select the desired
audio source.
The LEDs of the selected mode light up as followed:
AUX 1
green, steadily
AUX 2
green, flashing
BT (Bluetooth
)
blue, steadily
®
32
(1, 17) on the main unit or on the remote control.
(1, 17), to turn on the device. Press the on/off switch
again to switch the
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
