Inhoudsopgave
Advertenties
BoseProfessional.com
Mounting Instructions
The EX endpoints can be mounted using one of three methods: Mounting wing brackets as shipped
(outside mount), mounting wing brackets rotated 180 degrees (inside mount), mounting using the
optional EX Mounting Bracket.
Note: Use only the hardware included in the package to mount this product.
Mount with Wing Brackets Out
To mount the endpoints with wing brackets out:
1.
Use "outside mount" hole locations on enclosed template to mark mounting surface with location of
screw holes.
2. Install supplied screws. Leave sufficient space between screw head and mounting surface to
accommodate the thickness of the wing bracket.
3. Position endpoint on screws at wing bracket center holes. Slide endpoint forward or backward to
lock in position.
4. Tighten screws.
Mount with Wing Brackets In
Use this option when there is insufficient space to mount with the wing brackets out. To mount the
endpoints with wing brackets in:
1.
Remove the four screws (two on each side) that attach the wing brackets to the endpoint.
2. Rotate wing brackets as shows in figure. Re-install the wing brackets onto the endpoint by replacing
the four screws.
3. Use "inside mount" hole locations marked on enclosed template to mark mounting surface with
location of screw holes.
4. Install supplied screws. Leave sufficient space between screw head and mounting surface to
accommodate the thickness of the wing bracket.
5. Position endpoint on screws at wing bracket center holes. Slide endpoint forward or backward to
lock in position.
Installation and Operation
Installation Guide • 9
Advertenties
Inhoudsopgave
