Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Flame Effect
3.2.3 Press
turn the flame on/off.
3.2.4 Press the '←' and '→' button to select the 3 kinds of flame effect or OFF.
3.2.5 Press the '+' and '-' button to select the 5 brightness of flame effect and OFF
settings.
Fuel Bed Colour Adjustment
3.2.6 Press
to turn the fuel bed on / off.
3.2.7 Press the '←' and '→' button to select one of the 9 fuel bed colour options and
OFF.
3.2.8 Press the '+' and '-' button to increase the fuel bed brightness (5 options).
Heating function
3.2.9 Press
to turn on the heater. There are 4 heating modes: LOW, HIGH, OFF and
AUTO.
3.2.10 Press the '+' and '-' button to set the temperature from 5-40°C.
Timer
3.2.11 Press
to turn on the timer.
3.2.12 First press
to set the time to 0.5H, press the button again to cycle through 1H,
2H, 3H ,4H, 5H, 6H, 7H, 8H, 9H, 10H, OFF.
3.2.13 While the heater is in AUTO mode, set timer to turn all functions OFF including
Heating AUTO mode.
Window Open Detection
3.2.14 When the transmitter detects a rapid drop in room temperature, it will be judged
as a window open, the warning icon will be displayed, and the heating will be
turned off automatically.
3.2.15 After the indoor temperature has risen or a manual override of the warning (by
operating remote control) has been done, the fire will return to normal working
state.
Set up the communication between the remote and appliance
3.2.16 The below operations should be carried out before programming, when changing to a new remote or
in the event the appliance cannot be controlled by the remote:
3.2.16.1 Press the POWER ON/OFF button on the control panel for 3 seconds after turning on
the appliance, you will hear two long beeps from the unit.
3.2.16.2 Then within 10 seconds press the POWER ON/OFF button on the remote, a long beep
indicates that setting up the communication between the remote and appliance is done.
3.2.16.3 If not, repeat the steps above.
3.2.17 Resetting the code for remote control is necessary if the appliance operates wrongly or the remote
control does not operate correctly.
3.2.17.1 Open the back cover of the remote control.
3.2.17.2 Press the Reset button on remote handset.
12
Advertenties
Inhoudsopgave
