Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5.
Overview
Refer to the illustrations on page 2 of this manual.
1
on/off switch
2
fuse
3
power cord
7
interval/output time adjustment
8
smoke output adjustment
9
interval/output time switch
6.
Installation
Install the smoke machine in a well-ventilated place, at a minimum distance of 3 m from any
inflammable and explosive substance, and at a minimum height of 0.5 m.
Ideally, the smoke machine should be installed on a sturdy and level surface. If the smoke machine must
be hung up, please consider following guidelines:
Have the smoke machine installed by a qualified person, respecting EN 60598-2-17 and all other
applicable norms.
The carrying construction must be able to support 10 times the weight of the smoke machine for
1 hour without deforming.
The installation must always be secured with a secondary attachment e.g. a safety cable.
Never stand directly below the smoke machine when it is being mounted, removed or serviced. Have
a qualified technician check the smoke machine once a year and once before you bring it into service.
Install the smoke machine in a location with few passers-by that is inaccessible to unauthorised
persons.
Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the smoke machine itself checked regularly.
Do not attempt to install the smoke machine yourself if you lack these qualifications as improper
installation may result in injuries.
The installation has to be approved by an expert before the smoke machine is taken into service.
7.
Operation
Switch off the smoke machine and disconnect from the mains before proceeding.
1.
Unscrew the filler cap to open the tank. Fill half of the tank with a quality smoke liquid. We
recommend using the HQPower™ High-Density or the Pro High-Density smoke liquid. Make sure not
to spill any liquid so as not to damage the internal circuit of the smoke machine. Close the tank with
the filler cap.
Never run the smoke machine without liquid.
2.
Connect the remote control to the smoke machine. Insert the 5-pin XLR connector of the remote
control into the 5-pin XLR input connection [4].
3.
Insert the power cord into the mains.
4.
Choose whether to run the smoke machine as a stand-alone device or in a DMX512 configuration.
Stand-Alone Use
1.
Switch on the smoke machine [1]. Let the smoke machine warm up for 8 to 10 minutes. The green
LED [11] will light as soon as the smoke machine is ready for use.
2.
How to burst out smoke:
Simple smoke burst: Press and hold the green button [11] to emit a smoke burst.
o
Continuous smoke burst: Press the red button [10] for a continuous smoke burst.
o
Timer: Press the yellow timer button [9] and adjust the interval between two bursts with the
o
interval/output time adjustment knob [7].
V. 02 – 18/04/2013
VDP1500SM3
4
5-pin DIN/XLR connection
5
3-pin XLR connections
6
DIP switches
10 automatic smoke output switch
11 manual smoke output switch
4
©Velleman nv
Advertenties
Inhoudsopgave
