Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
- EN -
Hazards encountered by the combination of water and electricity
• The combination of water and electricity can lead to death or severe injury from electrocution, if the unit is incorrectly
connected or misused.
• Prior to reaching into the water, always switch off the mains voltage to all units used in the water.
Correct electrical installation
• Electrical installations must meet the national regulations and may only be carried out by a qualified electrician.
• A person is regarded as a qualified electrician if, due to his/her vocational education, knowledge and experience, he
or she is capable of and authorised to judge and carry out the work commissioned to him/her. This also includes the
recognition of possible hazards and the adherence to the pertinent regional and national standards, rules and regula-
tions.
• For your own safety, please consult a qualified electrician.
• The device may only be connected if the electrical data of the device and the power supply coincide. The device data
is to be found on the device type plate, on the packaging or in this manual.
• Ensure that the unit is fused for a rated fault current of max. 30 mA by means of a fault current protection device.
• Extension cables and power distributors (e.g. outlet strips) must be suitable for outdoor use (splash-proof).
• Minimum safety distance between the unit and the water: 2 m.
• Protect the plug connections from moisture.
• Only plug the unit into a correctly fitted socket.
Safe operation
• Never operate the unit if either the electrical cables or the housing are defective!
• Do not carry or pull the unit by its electrical cable.
• Route cords/hoses/lines in a way that they are protected against damage, and ensure that they do not present a
tripping obstacle.
• Only open the unit housing or its attendant components, when this is explicitly required in the operating instructions.
• Only execute work on the unit that is described in this manual. If problems cannot be overcome, please contact an
authorised customer service point or, when in doubt, the manufacturer.
• Only use original spare parts and accessories for the unit.
• Never carry out technical modifications to the unit.
• Only operate the unit if no persons are in the water.
• Keep the socket and power plug dry.
Installation
Place the unit at a height meeting the water level at a minimum distance of 7 ft. from the pond. Ensure that the unit
stands safely. Unlock the container locking system (A1), remove motor housing (A2). Remove all loose parts from the
collection container (A3). Refit and lock motor housing (A2). Push the hose end into the opening (A4) of the collection
container. Fit the extension tubes. Fit one of the supplied nozzles or set the adjustable bottom nozzle to the situation
your pond presents:
– Nozzle fully open (3/8 in.): Pond foil, no gravel on the bottom, thick layer of sludge
– Nozzle closed (1/16 in.): Pond film, gravel on the bottom, thick layer of sludge
Push the open end of the drain hose into the rear drain opening (A5) of the collection container. If possible, lay the
drain hose on the bottom such to allow gravity draining of the sludge water during automatic emptying. If necessary,
affix the sludge collection bag to the end of the drain hose.
8
Advertenties
Inhoudsopgave
