Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
12.5 Setup
12.5.1
Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
Place your appliance on a floor that is strong enough to support the appliance when it is
fully loaded.
Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
Ambient temperature below 16°C or above 38°C will hinder the performance of the
appliance.
This unit is not designed for use in a garage or any other outside installation.
Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 15 cm around the appliance.
WARNING! Do not close the ventilation openings in the device housing.
The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.
For energy saving reasons please ensure
that the door is closed when the
appliance is turned on.
12.5.2
Legs/feet
There are FOOT (3 bigger feet and 1 small
foot).
To level your appliance, adjust the front legs
at the bottom of the appliance.
12.5.3
The handle installing
The wine cooler comes with one metal
stainless steel handle. To install simply
screw them to the door with the supplied
screws. To do this, slide the rubber seal on
the back of the door to the side to lay open
the predrilled holes. Use the included
screws to install the handle on the door.
Then reinsert the rubber seal in the correct
position.
31
Advertenties
Inhoudsopgave
