Advertenties
Beschikbare talen
Beschikbare talen
ASSEMBLY
Fan grill assembly
1.
Fasten the rear grill onto the motor with four screws.
2.
Install the Blade onto the Motor Shaft by tightening the blade screw.
3.
Centre the Front Grill by aligning the logo on the grill Hub so it is horizontal and
parallel to the floor. Then secure the Front and Rear Grills completely together by
snapping grill clips into place. Lastly, tighten the grill locking screw at the bottom of
the Rear Grill.
Base assembly
1.
Unscrew the Fasten Ring and Base Locking Nut from the Stand Assembly.
2.
Insert the Stand Assembly through the hole in the center of the Base and twist into
position.
3.
Turn the Stand Base upside down with the Stand Assembly facing the floor and
place the Base Weight Support to the bottom of the Base. Tighten the Base Weight
Support to the Stand Base by the fastener and locking screw.
4.
Finally, connect the assembled fan head and stand with the connector screw and
nuts, ensure it's strong enough.
OPERATION
This appliance is equipped with 3 ventilation speeds. To switch on the appliance,
press one of the speed knobs. To switch it off, press "0".
Speed settings:
0 = OFF
1 = Low
2 = Medium
3 = High
This appliance also has an oscillation function:
Push the oscillation knob (7) to switch on the oscillation.
Pull the oscillation knob (7) to stop.
It is also possible to tilt the upper part of the appliance in order to adjust the airflow
direction vertically.
CLEANING AND CARE
Always disconnect the power supply cable from the power supply before carrying
out any cleaning operation.
To remove dirt from the plastic surfaces, use a soft damp cloth.
Use a vacuum cleaner to remove the dust from the guards without having to
disassemble them.
Never immerse the fan in water or any other liquid.
TKG VT 1029.2 CO
8
Advertenties
