Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2.0 PLACING
The HWO 1200 SUPER high pressure cleaner is equipped with air tyres which
allow the machine to move lightly even on difficult surfaces.
The DAMPCOMAT high pressure cleaner should be placed always as horizontal
as possible. Do not use the cleaner in an enclosed space and in rooms with
danger of explosion. Take care of sufficient water discharge and sufficient air for
the burner. Because of the smoke produced by the burner, the machine should
only be used in open air or in very well ventilated rooms. If the machine is to be
connected to a permanent funnel, place a trapezium shaped cap about 10 cm
above the chimney of the cleaner. Funnel diameter should be at least 18 cm.
Protect the machine in winter against temperatures below zero. Place the cleaner
in a frost-free environment or let antifreeze circulate through the machine.
2.1 ELECTRIC CONNECTION
In the factory the machine is already fully equipped with cables. The machine now
has to be connected to your own electric circuit. Connect the cleaner to a separate
group. Beware that voltage and amperage of your electric circuit meet the needs
of the machine. Therefore check technical details (9.0). Use only cables with the
right diameter. The factory advises to use cables of at least 2,5 qmm. Never lay
the plug and contact cover in water, and never put them in a place where it can get
wet from spraying. Danger for electrocution!
2.2 WATER CONNECTION (clean tap water)
For quick connection of hoses are cleaner and accessories equipped with high
pressure screw couplings and 3/4" water hose couplings. Beware that the cleaner
always gets sufficient water. The water consumption of the machine reaches up to
1000 ltrs/hour. That amount your water conduit should deliver. So use hoses of
sufficient diameter (3/4") and turn tap fully open. Beware that hoses do not bend or
leak. Do not place any heavy objects on hoses, nor place hoses over sharp edges.
3.0 FIRST USE
1. Check if the instructions mentioned above have been executed.
2. Check the oil level of the high pressure pump. Possibly oil has been lost
during transport. Fill if necessary with good quality oil (SAE 85-90) through the
black filler cap. The level has to be between the top of the oil glass and the red
dot on it.
4.0 OPERATING
Fill the fuel tank (fig. 1;1) with diesel oil or domestic fuel oil (red cap). The machine
is built for optional detergent usage, from:
• internal tank: this tank (fig. 3;169) and the filler cap are placed in the front of the
machine, next to the fuel tank (black cap).
• separate detergent can: place the suction hose in the separate detergent can
(front panel).
Refill detergent tank if necessary. Use exclusively good cleansing agents, in liquid
form to prevent blockages and slugging in hoses, pipes, tube coil etc. If powder
detergent is needed, mix them thoroughly with (hot) water and then use them in
All manuals and user guides at all-guides.com
20
Advertenties
Hoofdstukken
Inhoudsopgave
