Checking the Engine-Oil
Level
1.
Move the machine to a level surface.
2.
Remove the dipstick by rotating the cap
counterclockwise and pulling it out
Figure 16
1. Full
2. High
3.
Wipe the dipstick clean with a clean cloth.
4.
Insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
5.
Read the oil level on the dipstick
•
If the oil level on the dipstick is too low
(Figure
16), carefully pour a small amount
of SAE 30 or SAE 10W-30 detergent oil into
the oil-fill tube, wait 3 minutes, and repeat
steps
3
through
is at the correct level.
•
If the oil level on the dipstick is too high
(Figure
16), drain the excess oil until the oil
on the dipstick is at the correct level; refer to
Changing the Engine Oil (page
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
6.
Install the dipstick into the oil-fill tube securely.
All manuals and user guides at all-guides.com
(Figure
3. Add
(Figure
16).
5
until the oil on the dipstick
18).
Adjusting the Upper Handle
Height
You may raise or lower the upper handle to a position
comfortable for you.
16).
Note:
You cannot raise the upper handle higher than
the angle of the lower handle.
1.
Loosen the upper-handle knob
2.
Move the upper handle to the desired position
(Figure
18).
g232743
3.
Tighten the upper handle knob as tight as you
can
(Figure
9
(Figure
Figure 17
Figure 18
19).
Figure 19
17).
g010334
g010265
g010352