Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5. Set the On/Off switch of the kettle to position I (ON). The device will turn on and the LED
light will illuminate. You can interrupt the boiling process at any time by setting the On/Off
switch to position 0 (OFF).
6. The kettle automatically deactivates once the water has boiled. The On/Off switch sets auto-
matically to position 0 (OFF) and the LED light switches off.
7. Remove the power plug from the socket and take the kettle off of the base and carefully pour
the water into a suitable container. Keep the lid closed when pouring out the water.
8. If not in use, the kettle may be stored on the base. However, be sure to pull the mains plug
out of the socket.
If you accidentally use the kettle without any water, the device switches off automati-
cally. In this case, push the On/Off switch to position 0 (OFF) and let the kettle cool
off before using it again.
Cleaning and care
ATTENTION!
❐ Never submerge the device, the mains cable, and the plug in water or other liquids.
❐ When cleaning, do not use any aggressive, scouring or toxic cleaners.
❐ Prior to each cleaning, pull the plug out of the socket.
❐ Allow the device to cool off before cleaning.
•
Wipe the device off from the outside with a clean, damp cloth.
•
Keep the device in a ready-to-operate state. You should remove limescale from water on a
regular basis and according to the water quality in your region and the frequency of use. Use
a decalcifi er for this. Follow the instructions of the decalcifi er when decalcifying the kettle.
Troubleshooting
If the device is not working properly, please check whether you are able to rectify the problem
yourself fi rst. Otherwise contact customer service.
Do not attempt to repair a defective device yourself!
Problem
The device cannot be
turned on.
The device deactivates
before the water boils.
All manuals and user guides at all-guides.com
Potential cause/solution
•
Is the mains plug properly connected with the socket?
•
Is the socket defective? Try another socket.
•
Check the fuse for your mains connection.
•
Is the device overheated? Wait until the device has cooled off,
fi ll it with water and then retry.
•
Was the water level below the MIN mark?
15
Advertenties
Hoofdstukken
Inhoudsopgave
