Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3. Clean the kettle with a damp, soft cloth. To clean the kettle you can use a small amount of
mild detergent if needed and rinse the device off with clean, warm water afterwards. Dry it
off with a soft cloth.
4. The cable is wind up on the bottom of the base. Unwind the cord completely.
5. Place the base on a dry, water and heat-resistant, even surface with suffi cient space to fl am-
mable objects. Please ensure that the device is not accessible to children.
6. Insert the mains plug in a properly installed and grounded 220 – 240 V socket with earthing
contacts.
7. Fill the kettle with tap water up to the MAX mark and let it boil up (see chapter "Use"). Pour
the water away afterwards. Repeat this process twice.
The kettle is now ready for use!
Use
ATTENTION!
❐ Scalding hazard! Caution: Risk of emitted steam! Be careful when pouring out hot water.
❐ Scalding hazard! When the device is in use or shortly afterwards, avoid any contact with the
hot surfaces of the device (kettle and lid)!
❐ Allow the device to cool down before using the device again.
❐ Do not add more water than up to the MAX mark as water may spray out of the spout
during the boiling process otherwise.
❐ Fill the kettle at least up to the MIN mark with water! The device switches off automatically
when there is not suffi cient watter in the kettle.
❐ Each time before boiling, ensure that the lid is properly closed and that the On/Off switch is
not jammed. The device only switches off automatically, when the lid is closed and the On/
Off switch is not jammed.
❐ Remove the power plug from the socket, if you are not using the device,
1. Place the base on a dry, level, solid, water and heat-resistant surface and insert the mains plug
in a properly installed socket.
2. Take the kettle off the base unit. Open it by pressing the PUSH button on the upper part of
the handle and fi ll the kettle with drinking water. Make sure that the water level is between
the MIN and MAX marks. If there is not enough water in the kettle, the device will deacti-
vate before completing the boiling process; if it is fi lled past the MAX mark, water may spray
out during the boiling process.
4. Place the kettle on the base unit.
All manuals and user guides at all-guides.com
3. Close the lid. Make sure that you only touch the plastic applica-
tion when closing the lid (see arrow in the picture) to prevent
touching any hot metal surface by accident when the device has
been used recently.
14
Advertenties
Hoofdstukken
Inhoudsopgave
