Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
• When adding fluid, you can use the 2 setting for
1 - 2 minutes.
Operation
Preparation
1. Ensure that the function switch is in the 0 position.
2. Place the mixing jar in position.
3. Now put the ingredients that are to be mixed into the
mixing jar.
4. Put the lid on.
5. Close the refill opening with the cap.
Mixing
Operation is carried out with the setting control:
Level 0
= Off
Level 1
= Low rpm
Level 2
= High rpm
P
= High speed in pulse mode
WARNING:
• Always remove the plug before cleaning.
• Under no circumstances should you immerse the appliance in
water for cleaning purposes. Otherwise this might result in an
electric shock or fire.
• The blades on the knife block are very sharp. A risk of injury
exists!
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• The individual parts are not dishwasher-safe.
NOTE: Preliminary Cleaning
Half fill the mixing jar with water and turn the switch to P
for approximately 10 seconds. Then pour out the liquid.
• For thorough cleaning, please remove the mixing jar.
Fitting and Detaching the Knife Block
1. Turn the mixing jar on its head.
2. With a little effort turn the screw-cap counterclockwise
and detach the knife block.
3. Take the knife block carefully out of the mixing jar.
4. Remove the seal ring for cleaning.
5. After drying, place the seal ring back onto the knife block.
PC-UM1195_IM
Adding Further Ingredients to be Mixed
Items to be mixed or spices can be fed in through the filling
aperture.
1. Please switch off the appliance before doing so.
2. Before you switch the appliance on again, close the
opening.
Stopping Operation
1. Turn the switch to the 0 position.
2. Wait until the blade comes to a complete stop.
3. Remove the mains plug from the socket.
4. Remove the mixing jar. Turn it anticlockwise.
5. Take off the lid before pouring.
IMPORTANT NOTE:
Citrus juices and food containing acids should never be
stored in metal vessels.
Cleaning
6. Insert the knife block onto the thread on the bottom of
the mixing jar.
7. Tighten the screw-cap of the knife block by turning it
clockwise.
8. Ensure that the knife block sits securely in position.
CAUTION:
Only operate the appliance if you have properly fitted the
knife block with the seal ring! Otherwise the mixing jar will
not be sealed.
Mixing Jar, Lid, Knife Block, Screw-Cap,
Sealing Rings and Measuring Cup
Use a little dishwashing liquid and clean these components
in warm rinsing water. Then dry everything before assem-
bling the parts again.
33
09.09.19
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
