Advertenties
Beschikbare talen
Beschikbare talen
OBJ_BUCH-2332-002.book Page 21 Thursday, September 8, 2016 9:24 AM
Troubleshooting
TOP
Problem
Possible Cause
Machine fails to
Possible clogging
operate
Battery not fully charged
Battery not inserted (properly)
Grass too long
Motor protector has activated
Battery too hot/cold
Isolator key not inserted correctly/fully
There is a short delay in the motor starting after
engaging the On/Off switch
Motor starts and stops
Battery not fully charged
immediately
Isolator key not inserted correctly/fully
Battery not inserted (properly)
Battery too hot/cold
Machine functions
Internal wiring of machine damaged
intermittently
Motor protector has activated
Machine leaves ragged
Height of cut too low
finish
Cutting blade blunt
and/or
Possible clogging
Motor labours
Blade fitted upside down
Area of cut (battery
Height of cut too low
duration) not large
Grass too high
enough
Grass wet or damp
Grass is dense
An additional battery can be purchased from an
authorised customer service agent for Bosch
garden products
Cutting blade not ro-
Cutting blade obstructed
tating while garden
product switched on
Blade nut/bolt loose
Excessive vibrations/
Blade nut/bolt loose
noise
Cutting blade damaged
No charging procedure
Battery contacts contaminated
possible
The battery is defective, due to a disconnection
in the battery (individual cells)
Bosch Power Tools
Corrective Action
Remove the isolator key:
Check underneath the garden product and clear out
as necessary (always wear protective gloves)
Battery Charging
Inserting the battery
Increase height of cut and tilt garden product to re-
duce starting load
Allow motor to cool and increase height of cut
Allow to cool/warm
Fit correctly
Hold On/Off switch for 1 – 3 s to start motor
Battery Charging
Fit correctly
Inserting the battery
Allow to cool/warm
Increase height of cut
Contact Service Agent
Allow motor to cool and increase height of cut
Increase height of cut
Replace the blade
Check underneath the garden product and clear out
as necessary (always wear protective gloves)
Refit blade correctly
Increase height of cut and walk slower
Increase height of cut and walk slower
Wait until grass is dry and walk slower
Increase height of cut, walk slower and cut more fre-
quently
Contact Service Agent
Switch off garden product
Clear obstruction (always wear protective gloves)
Tighten blade nut/bolt (17 Nm)
Tighten blade nut/bolt (17 Nm)
Replace the blade
Clean the battery contacts (e.g. by inserting and re-
moving the battery several times) or replace the bat-
tery
Replace the battery
F 016 L81 430 | (8.9.16)
English | 21
Advertenties
