Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB Installation and Operating Instructions
LED recessed Light
Art. No. 500584, 500585
These operating instructions refer exclusively to these products.
They contain important information for the start-up and handling of the light.
Therefore pay attention to these operating instructions, even if you pass this product on to third
parties.
It is important, therefore, that these instructions are archived carefully for referring to information at a
later stage.
1. Introduction
Dear customer, thank you for deciding to purchase our product. You have acquired a product from Vollmer,
which has been built according to the current state of technology. The light fulfils the requirements of effective
European and national guidelines To maintain the condition of the product and to ensure safe operation, you -
as the user - must observe the instructions of this operation manual!
2. Safety Instructions
•
The guarantee becomes invalid if damage occurs due to the failure of following these operating
instructions!
•
We do not accept liability for any consequential damage!
•
Commissioning is strictly prohibited if there are any damages to the light.
•
Do not allow children to play unsupervised near the lights or other electrical equipment.
•
The lamps can become hot during operation. The outside of the lamp housing also becomes hot. Do not
touch the light with your bare hands during operation.
•
Do not allow the light to come into contact with extreme heat or naked flames.
•
The product in its entirety must not be altered or modified. Alterations to the light invalidate the
guarantee.
•
The type plate must not be removed.
3. Proper Use
The light is designed for use in indoor/ areas.
This product is only intended for lighting purposes and may:
•
only be operated with a voltage of 230V ~50Hz
•
only be connected according to protection class II (two)
•
only be operated when mounted to a sturdy, level and non-tilting surface
•
not be subjected to strong mechanical loads or heavy soiling.
•
the luminare shall be conected to the fixed wiring which have double insulation
4. Before Installation/Commissioning
•
The light may only be operated once removed from the packaging.
•
Remove the light from the packaging carefully.
•
Make sure that the light has not been damaged during transport before putting the light into operation.
The light may not be operated if there are any damages to electrical parts. Repairs may only be carried
out by a qualified electrician.
•
Keep packaging materials away from children and pets. Asphyxiation hazard!
5. Installation/Commissioning
•
This product can only be installed by a qualified electrician.
•
The connection lines in the building must be disconnected before installation and secured against being
switched back on. For this, trip the corresponding fuse switch in the building installation.
3 von 8 | 27.05.2022
Advertenties
Inhoudsopgave
