Inhoudsopgave
Advertenties
OPERATION
Electronic programmer
functions
1 –
function selection button
2 –
"–" sensor
3 –
"+" sensor
The electronic prgrammer is equipped with
electronic sensors which are switched on by
touching or pressing the sensor surface for at
least one second.
Each sensor reaction is confirmed by the
beep.
Keep the sensor surface clean at all times.
Setting the time
After connection to the mains or reconnec-
tion after a power cut the display shows flash
2
Press sensor 1, then the display will show
,
set the time using sensors 3 and 2.
7 seconds after the time has been set the
new data will be saved.
Caution!
If the correct time is not set then proper opera-
tion of the oven is not possible.
1
3
Timer
The timer can be activated at any time, re-
gardless of the status of other functions. The
timer can be set for from 1 minute to up to 23
hours and 59 minutes.
To set the timer you should:
Press sensor 1, then the display will show
flashing
,
2
set the timer using sensors 3 and 2.
The time set is shown on the display and the
signal function
Press sensor 1, 2 or 3 in order to switch off
the signal, the signal function will go out and
the display will show the current time.
Caution!
If the alarm signal is not turned off manually,
it will be turned off automatically after approx.
7 minutes.
17
1
3
is on.
Advertenties
Hoofdstukken
Inhoudsopgave
