Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ENGLISH
activated carbon becomes saturated after a period of time, which will reduce the adsorption
capacity of the filter. The carbon filter cannot be washed nor cleaned in any way. When its
service life comes to an end you must replace it with a new one.
-
It is recommended to check the condition of carbon filters regularly, at least two or three
times a year. Its replacement will depend on how the kitchen hood is used, as well as the
daily operating time.
-
In case of very frequent frying, shorten the time interval for checking and/or replacing the
carbon filters.
Installing the carbon filters
Remove the protective metal filters.
1.
2.
The carbon filters are located on both sides of the motor. Insert and turn the filters, until
they are firmly in place.
To replace the carbon filters, proceed in reverse order.
3.
4.
Carbon filters must not be exposed to heat.
Figure 11:
A: Closed
B: Opened
C: Opened
D: Closed
Carbon filter size > Φ176 x 35 mm
Replacing the light bulb/lamp
Please note
-
The light bulb must be replaced by the official Cecotec Technical Support Service or
similarly qualified technicians.
-
Always disconnect the power supply before performing any operation on the appliance.
When handling the bulb, make sure that it has cooled down completely before any direct
contact with your hands.
-
When handling the bulbs, hold them with a cloth or gloves to prevent sweat from coming
into contact with the bulb, as this may reduce the bulb life.
Note:
-
Before changing the light bulb, make sure that the appliance is switched off and unplugged.
-
Protect yourself from danger when changing the light bulb, e.g. by wearing gloves.
56
BOLERO FLUX DT 608002 GLASS BLACK/WHITE A++
BOLERO FLUX DT 908002 GLASS BLACK/WHITE A++
Advertenties
Inhoudsopgave
Probleemoplossen
