Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
General safety advice for electrical power tools / Before taking tool into use
firmly. This is much safer than holding it in
your hand.
W ear protective glasses! Pieces of mate-
rial may split off the workpiece and become
projectiles. This could cause injury.
Wear a dust mask! A dust mask must be
worn for prolonged work on wood or when
working on materials that give rise to hazard-
ous dusts.
D o not soak the materials or the area
to be worked with liquids containing
solvents. Unhealthy / poisonous gases may
develop from the heat generated by scraping.
M aterials containing asbestos may
not be worked. Asbestos is considered to
be a carcinogen.
U nder no circumstances should you
place your hands next to or in front of
the appliance or on the area to be
worked, you could be seriously injured if you
slip or stumble.
A lways have the cable leading away to the
rear of the appliance.
I n the event of danger, immediately remove the
plug from the power socket.
Original ancillaries / accessories
Q
U se only the ancillaries and accessories
that are detailed in the operating in-
structions. The use of ancillaries and acces-
sories other than those recommended in the
operating instructions could lead to an increased
risk of personal injury for you.
Understood everything?
Q
W hen you have made yourself familiar with
these general safety instructions for electrical
hand tool, then you can start with the work. You
will work at your safest when taking note of the
manufacturer's declarations and instructions.
All manuals and user guides at all-guides.com
Q
Q
The choice of the correct attachment tool is depend-
ant on the job to be done.
The supplied accessories are suitable for the most
widespread areas of application (see Figs. C, D, E,
F and G).
5
6
7
8
9
Q
Wear suitable protective gloves when inserting and
testing attachments tool
Notice: The curve / working edge of the attachment
tool
Inserting a tool attachment:
Removing a tool attachment:
Before taking tool into use
Attachment tools
Knife / Scraper attachment (offset)
Knife / Scraper attachment (straight), e.g. for
removing carpets, felts, cork sheets as well as
plaster and adhesive residues (see Fig. C, E)
Spatula attachment (flat), e.g. for removing
paint residues, silicon and foams (see Fig. D)
Chisel attachment (flat), e.g. for carving soft
woods (see Fig. F)
Carving chisel (13 mm), e.g. for carving in
softwoods (see Fig. G)
Changing attachments
.
4
must always point downwards.
4
P ush the tool lock
forwards to "UNLOCK".
2
I nsert the attachment tool
in the tool receptor
(see Fig. A).
3
P ush the tool lock
backwards to "LOCK" -
2
the tool attachment is locked.
P ush the tool lock
forwards to "UNLOCK".
2
R emove the inserted tool attachment
the tool receptor
.
3
as far as it will go
4
from
4
GB
33
Advertenties
Hoofdstukken
Inhoudsopgave
