Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
Pin assignment of the DMX connection: pin 1 = ground / pin 2 = (-) / pin 3 = (+).
b) Setup of a master/slave chain
In addition to the operation via DMX controller, the LED spotlight can also be used as a device within a
master/slave chain. In that case, the built-in controller of the master device acts as controller for any
connected slave devices.
• Connect the DMX OUT port of the master device to the DMX IN port of the first slave device.
• Connect the DMX OUT port of the first slave device to the DMX IN port of the subsequent slave device.
• Proceed the same way for all other subsequent slave devices. Connect an XLR plug with terminating
resistor to the DMX OUT port of the last slave device.
10. Power supply
The mains socket to which to connect the LED spotlight must be located near the device and be
easily accessible in order for the device to be disconnected quickly and easily from the mains
in case of any malfunction.
The mains cable must not get in contact with other cables.
Take care when handling mains cables and mains sockets. Mains voltage can cause fatal
electric shocks.
Do not leave cables lie around unsecured. Guide them properly in order to avoid dangers from
accidents.
Before connecting the mains plug, make sure the device voltage indicated on the LED spotlight
device matches the available mains voltage. If it does not match the mains voltage used, do not
connect the device. Using incorrect power supply could cause permanent damage to the device
or hazards for the user.
• The product is designed for mains operation.
• Connect the mains plug of the mains cable to an isolated ground receptacle.
• The LED spotlight starts after turning on.
28
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
