Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ENGLISH
Spot mode
Select this mode if you want to thoroughly clean a specific point in the map, making the most
of the robot's maximum power. The robot will clean a 2x2 m zone in zigzag motion and then
will return directly to the charging base when cleaning is completed. The robot will only clean
the area selected on the map, therefore it will go to the point and return to the base without
vacuuming.
It can only be activated from the App.
Restricted area mode
Select this mode and delimit in the map specific areas where you do not want the robot to
clean. You can set more than 1 restricted area at the same time on the map.
It can only be activated from the App.
Twice mode
Use this mode to carry out a deep, thorough cleaning of your home.
It can be combined with Edge, Spiral, Spot or Smart Area modes. The robot will carry out 2 full
cleaning cycles and then will return directly to the charging base.
7. CLEANING AND MAINTENANCE
Main brush
1. Turn the robot around and press the main brush's release button to take the cover out.
2. Take the main brush out and clean the compartment.
3. Clean the main brush with the provided tools and use water and soap if necessary.
4. Place the main brush in its position and fasten the cover's clip.
Recommendation: Replace the main brush every 6-12 months to ensure efficient operating
(depending on the frequency and type of use).
Fig.25.
1. Main brush cover
2. Tab
3. Main brush
4. Compartment
Silicone brush
Fig.26.
To clean the silicone brush, follow the instructions on the previous section to remove it from
the robot and wash it with water and soap. Dry it thoroughly before assembling it back in order
to ensure efficient operation.
40
Cepillo Jalisco (brush)
Fig.27.
To clean the Jalisco brush, follow the previous section's steps to take it out and clean it with
water. Dry it thoroughly before assembling it back in order to ensure efficient operation.
Dust tank
Fig.28.
1. Take the dust tank out.
2. Open the dust tank cover and empty it.
3. Use the cleaning brush to clean the inside of the dust tank.
4. Install the dust tank back in the robot.
Wet&Dry tank
Fig.29.
1. Take the Wet & dry tank out.
2. Detach the dust compartment from the rest of the tank.
3. Open dust compartment and empty it.
4. Use the cleaning brush to clean the dust compartment.
5. Assemble the dust compartment in the Wet & dry tank.
6. Install the Wet & dry tank back in the robot.
7. If the Scrubbing mode has been used, empty the water tank and then fill it with clean water
to rinse it. Empty it again before installing it back in the robot.
High-efficiency filter
Fig.30.
1. Remove the high-efficiency filter and shake it to remove all the dust.
Recommendations:
Replace the high-efficiency filter every 3 months depending on the frequency and type of use.
2. Clean the filter periodically with a brush to avoid blockage.
3. The filter can be washed with lukewarm soapy water. Dry it thoroughly.
Side brush
Fig.31.
Remove and clean the side brushes regularly.
Recommendation: In order to ensure a perfect cleaning, it is suggested to replace the side
brushes every 3 months, depending on the frequency and type of use.
Free-fall sensors
Fig.32.
Clean the free-fall sensors with a soft cloth regularly.
Warning: Always transport the product turned off and in its original package.
ENGLISH
41
Advertenties
Inhoudsopgave
