COMPONENTS (SEE PAGE 2)
Air outlet
1
Digital display
2
ON/OFF button
3
Pre-filter
4
Air inlet
5
DIGITAL DISPLAY (SEE PAGE 2)
Hygrosmart
Function
®
A
Clothes dryer mode
B
Night mode
C
Negative ionisation function
D
"Full tank" alert
E
USE PRECAUTIONS
• Make sure the product is placed on a dry, level surface.
• Leave at least 50 cm space behind, on the sides and in front of the unit.
• Make sure that the removable filter and the tank are correctly positioned and depressed.
• Do not remove the float from the tank, as this will prevent the unit from starting.
OPERATING INSTRUCTIONS
Make sure that the product is placed on a dry flat surface. Leave at least 20cm behind, around
and in front of the appliance. Make sure that the pre-filter and the tank are correctly placed.
1. Plug the appliance.
2. Press the ON/OFF button:
• The digital display will flicker during the stabilisation time and then, it will display the humidity
rate of the room air.
• Lary automatically starts in HYGROSMART
3. Press ON/OFF twice to select "CLOTHES DRYER" MODE.
4. Press ON/OFF a third time to select NIGHT MODE.
5. Press ON/OFF for a long time to turn the appliance off. The fan will stop after 30 seconds.
16
Continuous drainage outlet
6
Tank
7
Tank handle
8
Multidirectional casters
9
Continuous drainage hose
10
Display of the humidity rate of room air:
F
• Between 40 and 60%, the display is green to indicate
an ideal humidity rate.
• Below 40%, the display is blue to indicate a too dry
air.
• Above 60%, the display is red to indicate a too humid
air.
FUNCTION.
®
MAIN FUNCTIONS
HYGROSMART
FUNCTION: This mode allows you, at maximum speed, to maintain an ideal
®
A
humidity level in the air (between 47% and 53%). When the humidity level is below 47%, the
unit goes into standby mode: the compressor stops immediately and the fan stops after 30
seconds. If the humidity level is above 53%, the appliance automatically switches on again:
the compressor starts up again 3 seconds after the fan.
"CLOTHES DRYER" MODE: In "clothes dryer" mode, the appliance works at maximum speed
B
until the air humidity is equal to 20%. It is the perfect mode for laundry drying which needs
significant air dehumidification.
"NIGHT" MODE: Identical to the Hygrosmart
C
humidity level between 47 and 53%. The unit operates at low speed, the LEDs on the display
switch off after 10 seconds and it stops automatically without sounding a signal once the tank
is full. To reactivate the display, simply touch the button.
NEGATIVE IONISATION FUNCTION: This function automatically starts when you turn the appliance
D
on. It enables to clean the air and eliminate bad smells, thanks to the diffusion of negative ions.
TANK DRAIN (SEE PAGE 3)
"FULL TANK" ALERT: The appliance produces a sound signal once the tank is full. The
E
appliance turns off and the indicator becomes red. To empty the tank:
Turn off the appliance and pull out the tank using the handle provided.
1
Drain the condensate.
2
Reposition the tank.
3
Press the ON/OFF button and choose the desired operating mode.
4
The dehumidifier is equipped with a tank positioning sensor. As a matter of security, the product
turns off if the tank is missing or not properly placed.
ADDITIONAL FUNCTIONS (SEE PAGE 3)
CONTINUOUS DRAINAGE: Thanks to the continuous drainage hose, the appliance will work
independently without having to empty the tank. Make sure the hose is not bent and that it is
placed on a downward slope so that water can easily drain away. Do not modify or extend
the drainage hose.
Remove the tank.
1
Connect the drainage hose.
2
Pass the hose through the opening provided for this purpose before repositioning the tank.
3
AUTOMATIC ANTIFREEZE FUNCTION (DEFROST): The appliance automatically enters in defrost
function if the ambient temperature is between 5°C and 15°C. Every now and then, the
compressor stops but the fan continues to work.
function, this mode allows you to maintain a
®
17