Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
TROUBLESHOOTING
What to do if...
The control panel is
switched off, the appliance
does not work.
The inside light does not
work.
The temperature inside the
compartments is not low
enough.
The front edge of the
appliance, at the door striker
seal, is hot.
Acoustic signal sounds.
!
!
!
* Available only on certain models
Policies, standard documentation and additional product information can be found by:
•
Visiting our website
•
Using QR Code
•
Alternatively,
contacting our After-sales Service, please state the codes provided on your product's identification plate.
The model information can be retrieved using the QR-Code indicated on the energy label. The label also includes
the model identifier that can be used to consult the https://eprel.ec.europa.eu database portal.
Possible reasons
The appliance could be in On/Standby
mode.
There may be an appliance power
supply problem.
The light may need replacing.
The appliance could be in On/Standby
mode.
There could be various causes (see
"Cures").
This is not a defect. It prevents
condensation from forming.
Door open alarm
It is activated when a door remains open
for a long period of time.
Black Out alarm
It is activated in case of a prolonged
power outage causing an increase in the
freezer compartment temperature.
Note: A different product temperature
cannot be set until the Black Out alarm is
deactivated.
Freezer compartment temperature
alarm
The freezer compartment temperature
alarm indicates that the compartment
temperature is not optimum. This may
happen: with first use, after defrosting
and/or cleaning, if large amounts of
food are placed inside the freezer or
when the freezer door has not been
closed properly.
docs . whirlpool . eu
contact our After-sales Service
Solutions
Activate the appliance with the button 1.
Make sure:
•
there is not a power outage
•
the plug is properly inserted in the power socket and the mains
double-pole switch (if present) is in the correct position (i.e. allows
the appliance to be powered)
•
the household electrical system protection devices are efficient
•
the power cable is not broken.
Contact the Authorized service center.
Activate the appliance with the button 1.
Make sure:
•
the doors close properly
•
the appliance is not installed near a heat source
•
the set temperature is adequate
•
the circulation of air through the vents at the bottom of the
appliance is not obstructed.
No cure is necessary.
Close the doors of the product to deactivate the acoustic signal.
Before deactivating the acoustic signal, it is advisable to pay attention
to the Freezer temperature leds, corresponding to the highest
temperature reached in the freezer compartment during the black
out. Press the "Stop Alarm" button briefly to deactivate the acoustic
signal. After pressing the button, the temperature led shows the set
temperatures again. If the freezer compartment has not yet reached
the optimum food preservation temperature, the freezer compartment
temperature alarm could be activated (see freezer compartment
temperature alarm). Check the food before consuming it.
Pressing button 1
or
(See phone number in the warranty booklet). When
button 6, the acoustic alarm is snoozed
Advertenties
Inhoudsopgave
