Installing The Template; Installing The Internal Unit - Ariston NEVIS PLUS R32 25 MD0-O Handleiding
Verberg thumbnails
Zie ook voor NEVIS PLUS R32 25 MD0-O:
- Handleiding (29 pagina's) ,
- Gebruikers- en installatiehandleiding (160 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GB
1.3 Installing the template
NOTES:
Install the internal unit in a place free from all obstacles (such as
curtains) that could hinder the receipt of the remote control signals
and that allows for the air fi lters to be pulled out without causing
any inconvenience. Install the internal unit in a position where the
air fl ow will not be obstructed.
WARNING:
Install the template on a solid wall that is not subjected to any
vibrations.
1. Using a mason's level, position the template in such a way as to
ensure it is perfectly on-axis, both vertically and horizontally.
2. Fasten the template with 5 screws. Be careful not to pierce or
damage any pipes or wiring in conduits (risk of personal injury
from electrocution).
3. Then use the other screws to fasten the template to the wall
uniformly across the entire surface.
4. Make a hole in the wall for all piping and electrical connections
to pass through.
NOTE:
- Refer to the dimensions of the template (see photo) to defi ne the
optimum position for the holes. The holes should have a diam-
eter of at least 65 mm.
- Drill a hole in the wall that is 5-10 mm lower on the outside than
it is on the inside, so that the slope encourages downward fl ow
of the condensation.
1.4 Installing the internal unit
1. Push the piping, together with all cables, through the hole made
in the wall and hook the internal unit onto the top of the tem-
plate.
2. Shape the piping and cables well.
3. Push the lower part of the internal unit well up against the tem-
plate.
NOTE:
Keep in mind the fact that the hooks on the template are smaller
than the cavities at the rear of the unit. This allows you to adjust
the position of the unit, with the template already secured to the
wall, by approximately 30-50 mm to the left or right, according to
the model.
Make sure that:
a. The top and bottom hooks on the internal unit are securely fas-
tened onto the template.
b. The unit is fully horizontal.
If the appliance is not level, water may leak from it onto the fl oor.
c. The drain pipe is at the right gradient (minimum of 3 cm for each
metre in length).
d. The drain pipe stays at the bottom of the hole in the wall.
44 /
TEMPLATE
Advertenties
Hoofdstukken
Inhoudsopgave
