Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTRUCTIONS FOR USE
BEFORE FIRST USE
Before using the window vacuum for the first time, wipe it with a soft, damp cloth and dry thoroughly.
•
•
Do not immerse the window vacuum in water or any other liquid.
Ensure that the squeegee head is free from any debris (e.g. hair), as this could ruin the streak-free finish
•
or damage the surface of the glass.
CHARGING THE WINDOW CLEANING VACUUM
Before first use, the window vacuum must be charged for approx. 3–4 hours. Subsequent charging times
will take approx. 2–3 hours.
1. Connect the lead from the mains power adaptor to the charging port on the window vacuum.
2. Plug the mains power adaptor into the mains power supply; the indicator light will flash to confirm that
the battery is charging. Once the battery is fully charged, the indicator light will illuminate fully.
Note: Whilst charging, the window vacuum may become warm.
Caution: Exercise caution when charging the window vacuum; ensure that it is on a dry, stable surface
away from other appliances.
Warning: Do not use any mains power adaptor other than that supplied, as this could cause a hazard.
ASSEMBLING THE WINDOW CLEANING VACUUM
Attach the squeegee head by inserting it onto the top of the window vacuum main body; the arrow
indicators must be aligned. Twist the squeegee head in a clockwise direction to secure it into position.
ASSEMBLING THE SPRAY BOTTLE
1. Attach the wiper attachment to the top of the spray nozzle head.
2. Feed the suction hose through the nozzle clip; the spray nozzle head should face away from the lip.
3. Gently press in the lugs on the bottom of the wiper attachment and insert the assembled wiper
attachment/spray nozzle head into the nozzle clip, until it locks into position.
4. Add the spray head to the top of the spray bottle and twist it in a clockwise direction to secure it into
position.
5. Pull the microfibre wipe pad over the wiper attachment, allowing the elastic edges to hold it into
position. Secure it using the hook and loop tape.
USING THE WINDOW CLEANING VACUUM
1. Fill the spray bottle with a mixture of water and diluted window cleaning concentrate.
2. Use the spray bottle and the microfibre wipe pad to wash over the area of window to be cleaned.
3. To turn on the window vacuum, press the 'On/Off' button; push it again to turn it off.
4. Place the squeegee head against the window surface in a vertical position.
5. Clean the window from the top to bottom using long, straight, downward movements. This will avoid
leaving drip marks or smears on the window surface.
6. The window vacuum can now be used to remove any excess water remaining on the window surface.
Whilst switched on, hold the window vacuum vertically where the excess water has collected and allow
it to suck up the liquid.
Note: To lock the nozzle on the spray bottle when it is not in use, twist it in a clockwise direction.
The indicator light on the window vacuum will flash blue approx. 10–15 seconds before the battery runs
out of charge.
EMPTYING THE WATER TANK
1. Ensure that the window vacuum is turned off and unplugged from the mains power supply.
2. Detach the water tank plug from the base of the water tank and tilt to drain away any excess water.
Note: The water tank should be emptied after each use.
Warning: Do not allow the water tank to fill beyond the 50 ml Max. fill level, as this may cause water to
leak from the vents and cause damage to the window vacuum.
Advertenties
Inhoudsopgave
