Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5. Use
Connect the device to the mains and flick the power switch at the back of the device to ON. After the warm-up time
(approx. 4 minutes) the device is ready for use. The remote control is equipped with 2 rotary controls and 3
pushbuttons with corresponding LEDs:
• the "duration" rotary control allows to determine the duration of each activation
• the "interval" rotary control allows to determine the interval between activations
• the yellow pushbutton (TIMER) activates operation with interval
• the red pushbutton (POWER) activates or deactivates the remote control
• the green button (FOG) selects continuous smoke output. It may happen that the stand-by lamp on the remote
control is off and the smoke emission stops, even while you are holding the button. It means the device is
warming up again and will be ready in approx. 2 minutes. This process guarantees an appropriate vaporization
temperature and the best smoke emission possible.
6. Cleaning and Maintenance
1. All screws should be tightened and free of corrosion.
2. The housing, the lenses, the mounting supports and the installation location (e.g. ceiling, suspension, trussing)
should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting supports, do not
change the location of the connections, ...
3. Mechanically moving parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts, apart from the fuse (see "4. Installation").
8. Contact your dealer for spare parts if necessary.
9. Clean the heating element every 30 hours of use with a special cleaning liquid available from your dealer (order
code VDLCL). Fill the tank with 1/3 of the bottle of cleaning liquid and let the machine run for a while. When the
device is cleaned, remove the remaining cleaning liquid and rinse the tank thoroughly with distilled water. Never
use regular water for cleaning or rinsing!
10. Clean the device every 20 hours of use.
7. Technical Specifications
Power supply
Power consumption
Fuse
Smoke output
Warm-up time
Smoke liquid consumption
Tank capacity
Dimensions
Total Weight
Max. Ambient Temperature
Max. Housing Temperature
The information in this manual is subject to change without prior notice.
VDL800SMT
max. 230VAC/50Hz
max. 800W
F 5A, 250VAC (5 x 20mm) (order code FF5N)
100m³/min
approx. 4 minutes
approx. 25ml/min
0,75 litres
340 x 190 x 190mm
3,4kg
45°C
130°C
5
VELLEMAN
Advertenties
Inhoudsopgave
