Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6. Operating instructions
6.1 Overview
1.
Camera with IR LEDs and connection cable
2.
Monitor connection cable for 12 V vehicle socket
3.
Monitor
4.
Cable tie
5.
Bolts
6.
Nuts
Figure 1: Overview
6.2 Installation
These instructions are only valid as an example due to the various vehicle types and cannot be
directly used for every vehicle.
6.2.1 Checking the installation location for suitability
Before you start with the installation, check whether the location chosen is suitable for installation of the rear view camera.
Therefore hold both camera holders (item 9 in the overview), as precisely as possible over the rear license plate. The number
plate and the number plate lighting must not be covered by the camera. The camera and the holder must not block the boot
during closing. The camera can be mounted over or under the number plate. The camera must be mounted so that the cable
connection is located above.
6.2.2 Removing the rear number plate
First remove the rear number plate and, if present, also the number plate holder of your vehicle.
6.2.3 Pass through for the camber cable
If there is no opening behind the number plate that can be used for passing through the camera cable, you must drill a 10
mm diameter hole to lay the cable in the interior. In this case first remove the interior lining of the boot.
Check whether there are cables, wires or other components located at the position selected, which could be
damaged by the drilling.
When the hole for the cable to pass through has been drilled, protect the bare areas of the sheet metal with rust protection
paint or other suitable paint.
7.
Clamp connectors
8.
Gasket
9.
Camera holder
10. Monitor holder
11. Transmitter with connection cable
11
Advertenties
Hoofdstukken
Inhoudsopgave
