Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which
would have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise
the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
the door,
1.
Open
Within 60 seconds after the appliance was switched on press the
2.
for more than 5 seconds to enter the water softener setting mode.
button
3. Press the
Program button
environment, the
H1->H2->H3->H4->H5->H6;
4. Press the Power button to end the
WATER HARDNESS
German
German
French
French
dH
dH
fH
fH
0 - 5
0 - 9
6 - 11
10 - 20
12 - 17
21 - 30
18 - 22
31 - 40
23 - 34
41 - 60
35 - 55
61 - 98
1
dH=1.25 Clarke=1.78 fH=0.178mmol/l
°
°
The
factory
setting: H3
Every cycle with a regeneration operation consumes additional 2.0 litres of water,
1)
the energy consumption increases by 0.02 kWh and the program extents by 4
minutes.
switch
on the appliance;
again
to select the proper set according to your local
setting
will change in the following sequence:
British
British
Mmol/l
Mmol/l
Clarke
Clarke
0 - 6
0 - 0.94
7 - 14
1.0 - 2.0
15 - 21
2.1 - 3.0
22 - 28
3.1 - 4.0
29 - 42
4.1 - 6.0
43 - 69
6.1 - 9.8
°
setting mode
.
Water softner
Regeneration occurs
level
H1
No regeneration
H2
H3
H4
H5
H6
6
Program
Salt consumption
every X program
sequence 1)
10
5
3
2
1
(gram/cycle)
0
9
12
20
30
60
Advertenties
Hoofdstukken
Inhoudsopgave
