Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
N
3.2 Using your towel radiator and blower
3.2.1 name of the various Leds on your towel radiator
Radiator ON/OFF dial
Heating LED
Mode LED
Radiator ON/OFF LED
The heating Led indicates:
- that the radiator heating element is powered, when it is on;
- that a temperature sensor fault has been detected, when it is blinking.
If this occurs, refer to chapter 4 to solve the problem.
When the remote control is switched on, the mode Led indicates that a setpoint
temperature has indeed been registered by the radiator.
In the case of a pilot wire, the LED is on when the programming base unit is in
Comfort mode. This LED will remain off in any other operating mode.
When turned on, the radiator On/Off Led indicates that the radiator is ready
to receive instructions from the remote control to start (see chapter 3.1).
nOTe The blower operation and that of the electric radiator are independent. Your
blower can therefore operate when your radiator is switched off and vice-versa.
3.2.2 name of the various Leds on your blower
Blower ON/OFF dial
Filter LED
Alarm LED
Blower ON/OFF LED
38
All manuals and user guides at all-guides.com
can be activated by the remote control.
cause of this alarm.
the blower. If this is the case, the alarm and filter LEDs will blink simultaneously.
tion will allow you to access these parameters and modify them according to your
intended use.
P2 together to access the settings menu. The following information will then be
displayed on the remote control screen:
Press P2 to access the next parameter. (0
Press P1 to access the previous parameter. (2
When the blower is powered, the On/Off Led indicates that the blower function
The alarm Led indicates a blower failure. Refer to chapter 4 to identify the
The filter Led indicates when it is time to clean the filter (see chapter 4.2).
This LED also informs you of the absence or incorrect positioning of the filter on
3.3 Advanced remote control settings (for advanced
users)
Some of the remote control parameters can be adjusted. The following informa-
Access to the parameter settings is made with the remote control switched off.
If necessary, press and hold
to switch it off.
Once the remote control has been switched off, press and hold keys P1 and
Parameter number
1
Parameter value
2...)
1
0)
39
N
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
